How To

ProClean

Preparation for Cutek Pro Clean

Because of the wide variation in discoloration and timber species that are encountered, a test area should always be cleaned prior to commencement of the project to determine how much time the restoration procedure will require, and how much Cutek ProClean will be required.

This enables an accurate application procedure to be determined and cost estimated. It is important for the user to determine the suitability of the product for its intended application.

It is preferable to use Cutek ProClean as supplied and it must always be mixed well before use. Sometimes however, the use of hot water rinsing combined with an easy to clean surface, means that Cutek ProClean can be diluted with water. If a choice to dilute the product is made, always test to determine if the dilution being used is effective in cleaning

Cutek ProClean Application

Apply Cutek ProClean liberally to a pre-wetted timber substrate with brush, roller, or garden sprayer. Let Cutek ProClean do most of the work by letting it dwell on the surface for 10 minutes — 8 hours, or such time as deemed to be necessary by the test procedure. It may be necessary to scrub stubborn stains moderately with a stiff fiber brush.

Recoating

Following the restoration of the timber with Cutek ProClean, it is important to complete the restoration process by coating the timber with Cutek® Green. Application of Cutek® Green eliminates the need for any future stripping because it will not form a film that will peel off like a varnish. Additionally, it has been specifically designed to maximize the dimensional stability and aesthetic qualities of natural timber, while providing protection against ultraviolet degradation, moisture and biological growth. Always remember that film-forming coatings can peel and may need to be sanded, stripped, or scraped when reapplication is necessary.

It is important that the restored timber is completely dry before the application of Cutek® Green. Allow 3 - 4 days of hot, fine drying weather. If unsure, use a moisture meter to measure the residual moisture content of the restored timber to make sure that it is less than 18% before coating.